news | articles | reviews | software | modules | accessories | discussion | faq | mobile | store >> Discussion >> General Chat >> Visor General Chat
Visor cable

Post a New Thread | Post A Reply

  Last Thread   Next Thread
Topic: Visor cable    

Registered: Not Yet
Posts: N/A

Angry Visor cable

All of a sudden my visor prism cable won't connect properly: it goes in at an angle. I purchased a new cable--same problem. I had an old prism lying about and both cables go easily into it and begin charging at once.

Help--I'm going to lose my calendar!


Old Post 09-14-2005 02:27 AM
Edit/Delete Message Reply w/Quote

Registered: Aug 2000
Posts: 60

Sounds like the problem is in the Visor's connector, not the cable. Can you charge up the other Visor and beam the calendar to it, and then use it instead? Do you have a backup module you can use? Your calendar should be retained on the PC you sync with, too. It sounds like your Visor may need a bit of surgery to fix/replace the connector.

Comparing the two prism's, is the connector of one loose or do they appear to be different in any way (angle, set back inside the case, etc.)?

- Dwayne

dtrego is offline Old Post 09-14-2005 02:49 AM
Click Here to See the Profile for dtrego Edit/Delete Message Reply w/Quote
All times are GMT. The time now is 04:41 PM. Post New Thread    Post A Reply
  Last Thread   Next Thread
[ Show a Printable Version | Email This Page to Someone! | Receive updates to this thread ]

Forum Jump:

Powered by: vBulletin Version 2.3.4
Copyright ©2000, 2001, Jelsoft Enterprises Limited.