Registered: May 2000
Location: Washington, DC
Posts: 49

Whenever I try to reassign CMD keys to my Visor, I get a "Form.c, Line: 1272, Object not in form" error.

I have a new Visor Deluxe and recently purchased the Stowaway portable keyboard. Apparently there's a compatibility issue with MultiMailPRO III. After I assign a CMD key to MultiMail, if I try to reassign that CMD key, I get the fatal error.

Also, the keyboard does not work when plugged into the keyboard. I must first select the keyboard software, de-select, then select enable keyboard, before the software will work.

Again, watch for "Form.c, Line: 1272, Object not in form" fatal error.

I've e-mailed Actualsoft and Targus.

[This message has been edited by bnjacobs (edited 05-16-2000).]

Registered: Jan 2000
Location: Austin, TX
Posts: 12

I don't know about the fatal error but it sounds like you may be plugging the visor into the keyboard while it is still on. If it's off when plugged in, you shouldn't have to go through the deselect/select step in the keyboard software.