Registered: Dec 1999
Location:
Posts: 2

I was gonna pick up a pack of write rights, well actually the company was gonna pick them up at best buy for my visor. But I noticed that on inyourpalm they mention that the iii versions dont fit exactly is that true?, I noticed that they had visor protector for 25 and the others for 20, but the description for the visor said they were for the iii?

anyway
Mike

Registered: Dec 1999
Location:
Posts: 17

I ordered the ones for the palm III, they do leave a small gap on the sides. I have not seen them installed on a palm so I am not sure how this gap compares to the gap if any that would normally be there. I can say that it was NOT a very large gap and if the gap did not exist I do not know how I would ever get the stupid things back off.


big-b

Registered: Dec 1999
Location: Chandler, AZ
Posts: 289

I am using WriteRights for the PalmIII on my visor. They do have a small gap however, it is off the writing area so it isn't that big of a deal.

Joe

Registered: Dec 1999
Location:
Posts: 79

I put on my Dad's Visor yesterday and it seemed to fit just fine.....

It took me 2 years to go through my first pack of Write Wrights....the new pack I bought has the stupid Write Writes logo at the bottom of the plastic that now shows on the Visor.....I HATE IT. DON'T PUT JUNK ON MY SCREEN!!!!!!

Heyday

Registered: Nov 1999
Location: Ann Arbor, Michigan USA
Posts: 790

I have Win CE WriteWrites on my Visor. Like Big-B, I've never seen how they are supposed to fit, but much smaller of a gap and I'd think they would be hard to remove.

As to the onscreen logo, UGH! I agree that is lousy!

Registered: Dec 1999
Location:
Posts: 52

would it be possible to "cut out" the logo and just live with the small area not protected? Is the logo in the bottom corner?

Harry

Registered: Dec 1999
Location:
Posts: 79

The logo is at the very bottom in the Center. It doesn't take up too much room but I notice it. I guess you could cut it out.

Heyday

Registered: Dec 1999
Location:
Posts: 6

I have the Palm III WriteRights, and while they do have a gap, if you center them in the screen, the gap on either side isn't even big enough to fit the tip of your stylus in.

Registered: Sep 1999
Location: San Francisco, CA
Posts: 431

If you don't like the logo at the botton of the WriteRight, I suggest you e-mail ConceptKitchen and let them know. I did.