Registered: Aug 2001
Location:
Posts: 7

Constant Fatal Exceptions

Starting earlier today, I tried to hotsync my visor platinum. After the hot sync, I got a fatal exception. I could not get rid of it without doing a power down reset.

To be extra cautious, I even deleted all third party apps from my desktop computer. After the power down reset, I tried to hotsync, so as to add my appointments, addresses, etc. back. However, all of the applications which I had deleted (both from the computer and the visor) updated themselves and installed themselves on the visor. They were not on the install tool -- I checked (and I DO NOT have any back up software, although I wish I did).

Again I got a fatal exception, which cleared up using a system reset.
Making sure no hacks were active, I then performed a soft reset as per the handspring support page, and again got a fatal exception. Any ideas?

Last edited by tjevans on 08-21-2001 at 03:38 AM

Registered: Aug 2001
Location:
Posts: 7

Fixed It

Ok, after the last reset, I went in and deleted all the apps that had been installed just prior. After installing them one by one, I found the offender was grafixpad.