Registered: May 2000
Location: Lambertville, MI
Posts: 25

After repairing a unoperational To-Do Button, and putting my Visor back together, I found that 3 lines of display are gone from my display. Does anyone have any method as too how to fix this, or is it even covered by warrenty. I doubt "Screwed up by tampering doofas" is covered, but any ways to rectify the problem would be grately appreciated.

------------------
<><

Registered: May 2000
Location: Washington, DC
Posts: 49

I've taken apart my VDx. Actually, I made one good Vdx out of two defective ones.

The obvious thing that comes to mind is trying to reseat the screen's cable. As you know, it simply slides into place and is held by a small piece of plastic that holds the contacts in place.

As I recall, it's a tight fit. Any change you didn't seat the cable properly or crimped it while closing the two halves together?

Registered: May 2000
Location: Lambertville, MI
Posts: 25

I tried screwing with the thing, Didn't do much, I might as well go at it agian.

------------------
<><