Registered: Jan 2000
Location:
Posts: 9

Someone tried to beam me his business card at a meeting today. His Palm 3 couldn't find my Visor. I looked in Prefs, and Beam Rcv. was set to off. Tried to switch it to ON but it wouldn't switch :-( Then I tried to beam him my business card but it gave me an error message:
There are no exchange libraries available.

Any ideas?

Registered: Feb 2000
Location:
Posts: 41

I haven't tried beaming, but I searched the forums for beaming and found this.
http://discussion.visorcentral.com/...TML/000886.html

------------------
Deb Auld

Registered: Apr 2000
Location: Oakland, CA USA
Posts: 61

This error message occurs if you try to beam after performing a warm reset--a reset where you hold the up button while resetting.
You'll also notice that your visor will ignore incoming beams. (I think this is because IrDA is disabled by the warm reset.)

A soft reset should fix the problem.

--Jen