Registered: Dec 1999
Location: Kuala Lumpur
Posts: 247

I recently noticed a problem with my InnoPak/2V.

What happens is that, two times so far, the InnoPak/2V that I bought recently has caused my Visor to go into an infinite reset loop, necessitating a hard reset of my Visor Deluxe.

I�m not sure what I did, but I�ll try to be as detailed as possible about what I was doing when that happened:

1. The first time it happened was just a simple matter of changing batteries � I had the 2V in my Visor, and I took out the batteries and replaced them with a new one. I can�t remember whether I had the Visor on or not, but I think I had it off. Anyway, when I looked at my Visor screen next, the screen was all garbled. I pushed the reset pin into the hole and did a reset and the PalmOS startup screen appeared, but it was stuck in a continuous reset loop. Fearing the worst, I took out the InnoPak and tried to reset again, and it still was stuck in an infinite reset loop. I tried doing a warm reset and it was still stuck. Finally a hard reset had to be done and I lost all my data (at least until the next HotSync).
2. The second time it happened was when I pulled out the InnoPak from the Visor a couple of times. The screen once again became garbled and got stuck in an infinite reset loop. I had to do a hard reset again.

I have tested my Visor for the DRAM problem and I DO NOT have the faulty DRAM.


What I do have installed on my Visor are:

1. Launcher III
2. MiddleCapsHack