Registered: Dec 1999
Location:
Posts: 25

I bought one of those $25 nice pen/stylus combos for my Palm III, but now that I am waiting for my visor, I am wondering if it will even work.

Can anyone confirm if the Palm stylus are the same size/shape/connector as the Visor stylus?

Registered: Nov 1999
Location: Ann Arbor, Michigan USA
Posts: 790

Any stylus can be used to tap or enter Grafiti on the Visor.

The "compatibility" concern is that unless a stylus is made for the Visor specifically, it will most likely not fit in the little groove in the side of the Visor body.

Hope this helps.

Registered: Nov 1999
Location: West Palm, FL
Posts: 53

As the above post stated any stylus will work for data entry, but if you want a non Handspring stylus that will fit in the storage slot on the side of the visor you can buy the 3 pack of styli from 3com for the old Plam Pilot. These will fit but dont waste your time on the styli for the IIIx or Vx. Good luck.

Registered: Nov 1999
Location: Ann Arbor, Michigan USA
Posts: 790

Now there are 2 Visor-specific stylii at http://pdapanache.com/

[This message has been edited by PDAENVY (edited 12-13-1999).]

Registered: Nov 1999
Location:
Posts: 16

I just received the chrome Visor stylus from www.pdapanache.com. I must say, it's a beautifully made, solid product. The only problem is, now I can't wait for my VDx to get here so I can actually start using it! :-)