nwhitfield
Member

Registered: Feb 2000
Location: London, UK
Posts: 92 |
Have you set the Network option in the IrLink prefs to IrDA?
I'm not too hot on GPRS, I'm afraid - you'll need to look at the docs for the phone and possibly hunt around to find out what details are needed to make it set up the connection.
However, I'd advise that before delving into GPRS, you establish whether or not the Visor is talking to the phone properly, making an ordinary GSM data call.
IrLink simply detects that there's a device in range when you use the discovery option, not that it's linked to the Visor's Network prefs.
So, I'd tap Mixed in the IrLink setup screen, make sure that Network (at the bottom) is set to IrDA, and then go to the Preferences app, choose Modem, and set to standard modem, no handshaking. Then go to Network, and enter the detail of a dial up isp, and hit connect, to see if the Visor can at least talk to the phone and make it dial.
If that works, then you can worry about the AT commands for setting up a GPRS connection.
I've not tried these myself, but one of the columnists for a magazine section I edit submitted text about it for the November 2001 issue of PCW. I paraphrase....
Essentially, since most gizmos are looking to set up a dialing string with ATD.
To specify GPRS, you dial *99# instead. You also need to specify the access point name given by your provider. That is done with the AT+CGDCONT command.
For example, AT+CGDCONT=1,"IP","serviceinfo" where you replace serviceinfo with the access point name. You can also, apparently, specify "PPP" or other protocols instead of plain IP. You may need to add a config option to disable wait for dial tone.
Of course, not having a GPRS phone myself, I can't test this, but I hope it gives you something to go on.
Nigel.
|